“THE BOMBAY ENGINEERING WORKS”
COLLOID MILL is suitable for homogenising emulsifying
dispersing, mixing, comminuting of liquids to highly viscous
products. It is based on rotor – stator principle,
It is available in plain as well as water jacketed in
both STD & GMP models.
Product is feed to the operating ares of a rotor,
having a speed of 3000 R.P.M by specially designed feed
device. The product is processed by high sheer, pressure
and friction between the stator and rotor , the angular
gap becomes narrower towards the discharges section. This
processed product continously leaves the mill through
the drain pipe, if required, it can be recirculated.
All contact parts are made out of S.S. 304 (S.S.
316 on demand at extra cost). No castings are used
to avoid contamination problems.
Coupling provided between motor shaft and rotor
shaft for ease in maintainence.
Three leak proof neoprene sealing device between
the motor and the processing chamber to prevent liquid
going in the motor winding.
Modified design of semi concave teeth in rotor
and stator reduces motor h.p. and gives better performance
in size reduction without damaging the products.
Extended bearing housing specially designed to
facilitate fine metal contact of rotor and stator.
This unique design provides smooth and consistence
all around performance and long life of rotor and
Three way cock system for draining and recirculation
of the liquids provided as standard. Extra discharge
sprout provided as a standard for viscous products.
DOL starter with overload relay for protection
against single phasing and low voltage.
Contact parts can be easily dismantled for cleaning.
Special design facilitates adjustments of the grinding
gap by exterior screw by means of handle even during
Flame proof motor and Flame Proof rotary switch
can be provided on request at extra cost.